Description
SURFACE PREPARATION
All surfaces to be bonded should be dry, smooth, and free of any contaminates that may affect final bond. All surfaces must be prepared in accordance with current Australian Standards 1884
Floor Coverings Resilient Sheet including moisture testing. It is recommended that all highly absorbent sub floors be primed with Master primer prior to the application of adhesive. The minimum sub floor temperature prior to commencing preparation or adhesive application is 10°C.
DIRECTIONS FOR USE
Apply adhesive using a 3.2mm x 3.2mm x 3.2mm “V” notched spreader. Coverage should be in the vicinity of 2m² per litre. Some domestic sheet vinyl may require a fine 1.6mm x 0.8mm x 0.8mm“U” notched trowel to prevent adhesive ‘show through’. Adhesive can be allowed to tack-up prior to placing the floor covering into the wet film of adhesive. Tack-up time will depend on atmospheric conditions. Always ensure complete transfer of adhesive to the floorcovering has occurred. Complete installation according to manufacturer’s instructions. Roll installation on completion with the recommended weight roller.
Do not allow heavy traffic for 24 hours.
CLEAN UP
Clean tools immediately after use with warm soapy water.
TYPICAL PROPERTIES
Base: Acrylic
Solids: Approximately 70%
Shelf Life: 12 months in sealed container at 20°C
PACKAGING
15ltr Bucket.
CAUTION
Always carry out your own test to confirm suitability of this product with your application. Additional information on physical properties, health hazards, storage, handling and transport is available in the Safety Data Sheet (SDS), available on request.
SDS
